Call 08048078907 71% Response Rate

our range

Monel Fastener

We are a leading Manufacturer of monel 400 alloy 400 uns n04400 fasteners and monel k500 uns n05500 fasteners from Mumbai, India.
Monel 400 Alloy 400 Uns N04400 Fasteners

Monel 400 Alloy 400 Uns N04400 Fasteners

Rs 100  / PieceGet Best Price
MaterialMonel
BrandAM
Size1/4" - 4"
GradeAlloy 400, Nickel 400, UNS N04400, Monel Alloy 400
Bolt TypeHEX HEAD
Country of OriginMade in India

Monel 400 shows high strength and excellent corrosion resistance in a range of acidic and alkaline environments and is especially suitable for reducing conditions.[22] It also has good ductility and thermal conductivity. Monel 400 typically finds application in marine engineering, chemical and hydrocarbon processing, heat exchangers, valves, and pumps. It is covered by the following standards: BS 3075, 3076 NA 13, DTD 204B and ASTM B164.[23]

Large use of Monel 400 is made in alkylation units, namely in the reacting section in contact with concentrated hydrofluoric acid.

View Complete details

get quoterequest a call back
Monel K500 Uns N05500 Fasteners

Monel K500 Uns N05500 Fasteners

Rs 100  / PieceGet Best Price
MaterialMonel
BrandAM
TypeHEX HEAD
Size1/4" - 4"
GradeMonel Alloy K500, Nickel K500 (NA18, N05500)

Monel K-500 combines the excellent corrosion resistance characteristic of Monel alloy 400 with the added advantages of greater strength and hardness.[28][29] The increased properties are obtained by adding aluminum and titanium to the nickel-copper base, and by heating under controlled conditions so that submicroscopic particles of Ni3 (Ti, Al) are precipitated throughout the matrix.

The corrosion resistance of Monel alloy K-500 is substantially equivalent to that of alloy 400 except that, when in the age-hardened condition, alloy K-500 has a greater tendency toward stress-corrosion cracking in some environments. Monel alloy K-500 has been found to be resistant to a sour-gas environment. The combination of very low corrosion rates in high-velocity sea water and high strength make alloy K-500 particularly suitable for shafts of centrifugal pumps in marine service. In stagnant or slow-moving sea water, fouling may occur followed by pitting, but this pitting slows down after a fairly rapid initial attack.

Typical applications for alloy K-500 are pump shafts and impellers, doctor blades and scrapers, and oil-well drill collars, instruments, and electronic components.

View Complete details

get quoterequest a call back

EXPLORE MORE CATEGORIES